D.I.Y. - Honda 99 - 00 Mugen Style Front Lip - By Omar Lopez

D.I.Y. - Honda 99-00 MUGEN STYLE Front Lip

So you just bought your damn smexy Honda mugen lip. Gotsss to get that sex on now. So hopefully you could do this with this help. Works BEST on LS LT and LTZ. iam not responsible for this thing falling off, messing up your front end up, ect ect. Work at your own risk. This will make you super angry when working on it.

Step: 1 Cut off the small tab on the upper part of the lip to keep it nice a straight for when it goes on the car.

When on car it should sit “flush with body”

Step: 2 m3 tape the whole inner part of the lip.
*Pic is not the proper lip just an example of what should be done. *

Step: 3 we are now outside near the car. line the lip up with the body on either the passenger wheel weld side or driver wheel weld side. The stock rubber lip should be just a tad bent. But lip should cover most.

Step: 4 we are now drilling in two holes on the side you chose to work on first.
Also add your screw of choice and washer of choice. Would recommend some good long wood screws, and a fat washer head, to make sure it stays in.

Step: 5 we now SKIP THE MIDDLE go to the opposite side. Ex *If you started on driver, go to passenger* and again repeat with the same two holes

Step: 6 now take off the red m3 tape cover.

Step: 7 Now we sit at the MIDDEL of the car. and now lift the full lip up. So it should look like its fully on. Have someone or something hold it for you at this point. To let the m3 tape fully stick on.

++As you are now waiting for the m3 tape to stick continue on and work on the next steps as someone or something holds the Honda lip up. ++

Step: 8 now UNDER the car starting at the passenger side. ADD on L shape bracket. Drill up to the front Sonic bumper and drill through the Honda lip. Once again use some hard core screws and washers.
Total of 2 screws 1 bolt and 1 nut. Two going up in the sonic front bumper and one screw with bolt going trough the honda lip.

Step: 9 Now at the MIDDEL of the car two more of these L brackets go on.
Total 4 screws 2 bolts and 2 nuts. Screws go through the under half of the sonic front bumper and bolt with nut go through the Honda lip.
*these brackets are bent because I can’t drive and curbed it…..*

Step: 10 just simply repeat step 8. 2 screws go trough the under half of sonic front bumper and 1 bolt and nut trough Honda front lip

Step: 11 WE almost done finally. Go ahead and recheck the full lip to make sure its not crooked, or any gaps show, if so pull the lip up higher and redrill again.
Should sit up with almost two finger gap with the body line.

Step:12 Paint the lip with color of choice if you choose too, or paint the screws heads so they aren’t too noticeable

You are now fully done with the look and enjoy ! iam not responsible for this thing falling off, messing up your front end up, ect ect. Work at your own risk. Hopefully this helps or gives an idea on how to install the Honda mugen style front lip.
If you wants to buy it here is the link