D.I.Y. - ZZP Cable Clamp - By Richard DeFries

D.I.Y. - ZZP Cable Clamp

1. Gather Your Tools / Parts - ZZP Cable Clamp - 10 MM Socket - 1/4 Inch Drive Ratchet - 3 Inch 1/4 Inch Drive Extension - Flat Head Screw Driver - Allen Key (Don't Remember Size DOH)

2. Park Your Car . Engage Your Parking Brake / E - Brake . ! Safety First !

3.Pop Your Hood And Locate Your ECU Off The Side Of Your Battery You Will See Small Red Tabs On The Wiring Harness Going Into The ECU Above That Press The Tab In And Gently Pull The Bar Up To Release The Harness (Ref Pic 1)

4. With The Harness Removed Get Your Ratchet - Extension - 10 MM Socket And Remove The 4 Nuts Holding The ECU In Place (BE GENTLE AND CAREFUL)

5. Use Your Flat Head Screw Driver To Pop The Shifter Bushing Free From The Shifter Arm (Ref Pic 2)

5. Prepare Your ZZP Cable Clamp (Ref Pic 3) And Install It On The Factory Bushing Then Tighten The 3 Allen Keys To Tight And A Little Push For Good Measure

6. Now Push The ZZP Cable Clamp Back Onto The Shifter Arm You Should Feel It Kind Of Pop On (Ref Pic 4)

7. Put Your ECU Back Into Place And Tighten The 4 - 10 MM Nuts. The Wiring Harness For Your ECU Is Color Coded So Match The Colors. Push The Harness Back On And Once It Sets Firmly Push The Bar Down To Secure The Harness Back To The ECU You Should Here A Click For Each Of The 3 When It's Fully Attached

8.Sit Back And Enjoy Your Hard Work!